LCD 3D Printer-LCD-120
【BUILD AND MOTION】 Great emphasis is being placed on the LCD-120’s robust build quality and the components of its motion system, which is underpinned by a ball screw and single linear rail for the Z-axis.
【ANTI-ALIASING】 MSLA 3d printer uses an LCD screen to mask an image of a layer over a UV light source. Comprised of hundreds of thousands of pixels, each a little rectangle itself, this tech leaves a telltale sign of the edges of these pixels on the print surface. Often barely visible, this effect can be lessened through the use of a digital processing called anti-aliasing, which interpolates between these edges, smoothing the effect out.
【QUICK LEVELING】 Quick leveling in the sense that the machine will lower the print plate to the vat for you, yes the LCD-120 is quick leveling. Four hex screws feature on the print plate — loosen them before dropping the plate, and it will align to the level of the screen. Tighten and you’re good to go. Standard MSLA fare.
【PERFORATED PRINT PLATE】 Something of an oddity on a small desktop MSLA machine, the LCD-120 has a perforated print plate. Typically seen on larger bottom-up machines where larger prints present additional pull that might dislodge an improperly adhered print, it’s unusual, and perhaps even distracting overkill, to see it on a smaller machine. It’s not a bad thing, but it makes you wonder why they did it.
【AIR FILTER】 A small box at the rear of the print chamber contains a pouch of activated carbon. This should help to remove part of the stench of exposed resin from the air.
Dentistry, industry, jewelry, education, design, etc
Print models display
|Light source||LCD screen; parallel UV light board provides homogeneous radiation|
|Z-axis lifting system||/|
|Resin tank||Full metal tank|
|Printing method||SD card offline printing, network printing, and WIFI printing; support preview of printing progress|
|Operation system||Compatible with Windows XP/Vista, MAC, Linux,|
|Power supply||100-240V, output 12V, 72W|
|Slicing software||3D Creator Slicer for LD|
|Material||Ordinary rigid photosensitive resin, standard resin, elastomeric resin, highly-resistant resin,dental resin|